The outdoor station is the first component to install. Follow these steps:
Connect the wires to the terminal block on the back of the DP-RA01 handset according to the wiring plan outlined in Section 3. Ensure the screw terminals are tight and no stray wire strands are touching adjacent terminals. Step 5: Mount the Handset
Once installed, using the DP-RA01 is straightforward: commax dp-ra01 installation manual
Strip approximately 5-7mm of insulation off the ends of each wire conductor.
Align the slots on the rear of the DP-RA01 handset with the hooks on the wall bracket. The outdoor station is the first component to install
Now, let’s get it on the wall.
Strip approximately 5mm of insulation from your signal wires. Step 5: Mount the Handset Once installed, using
To use the system effectively, you need to understand the key components of the and Slave (S) stations.
Intercom installation involves electrical components. Always follow these safety basics:
This comprehensive installation manual provides step-by-step instructions, wiring diagrams, and troubleshooting tips to ensure a successful installation. Technical Specifications
