Dc-unlocker Commands List -

| Category | Example AT Command | Usage | | :--- | :--- | :--- | | | ATI | Gives manufacturer information of the modem. | | | AT^CGMR | Gives the firmware version. | | | AT^CGSN | Gives the IMEI (International Mobile Equipment Identity) number. | | Unlocking Commands | AT^CARDLOCK? | Checks the SIM lock status and the number of remaining unlock attempts. | | | AT^CARDLOCK="xxxxxx" | Enters the unlock code (where xxxxxx is your specific code) to remove the network lock. | | Diagnostic & Mode Control | AT^U2DIAG=0 | Puts the device into Modem Mode (essential for unlocking or firmware updates). | | | AT^U2DIAG=1 | Enables Modem and CD-Rom Mode (the standard mode for most dashboards). | | | AT^U2DIAG=256 | Puts the device into Modem + Card-Reader Mode (for accessing storage). | | | AT+ZCDRUN=F | A ZTE-specific command often used to wake up a modem or switch its mode. | | Voice Feature Management | AT^CVOICE=? | Queries the current voice feature status (enabled or disabled). | | | AT^CVOICE=0 | Enables the voice feature on supported Huawei HSPA modems. | | System Configuration | AT^SYSCFGEX=? | Queries the available system modes, bands, and roaming settings. | | | AT^SYSCFGEX=<acqorder>,... | Sets specific network acquisition orders and frequency bands. | | General Control | ATZ | Resets the modem to its default configuration (a good first step for troubleshooting). | | | AT^CFUN=1 | Restarts the modem. | | Command Discovery | AT^CLAC | Lists all supported AT commands for your specific device. |

Here’s a helpful, honest review of the based on typical user experiences:

AT^CARDUNLOCK="[HEX_CODE]" — Resets the unlock attempt counter if it has been blocked (0 attempts remaining). dc-unlocker commands list

REM Perform Unlock echo Attempting unlock... dc-unlocker.exe ^unlock

Ensure you have installed the correct USB drivers. Try a different USB port (preferably rear USB 2.0 on desktops). | Category | Example AT Command | Usage

- Unlocks the device using a specific unlock code obtained via the software.

These commands interact with the SIM lock status of the modem or router. | | Unlocking Commands | AT^CARDLOCK

He took a deep breath and typed the third command, the one Phantom_Zero called 'The Golden Key'. AT^DATALOCK=0

Force your modem to stay on a specific network type (like LTE only) to prevent it from dropping down to slower speeds. For Huawei Devices:

: Shows the current network operator the device is connected to. : Checks the GPRS registration status. AT^SYSINFO

| Command | Description | |---------|-------------| | imei <new_imei> | Change IMEI (where allowed) |