The progress bar at the bottom will begin to fill up, showing the writing and verifying process.
While holding the button/pads, connect the USB-C cable from the device to your PC.
Fix: This indicates a bad flash or incompatible firmware version. Repeat the process using an older, stable version of the official firmware to restore functionality.
Click the file selection button and load your downloaded .bin firmware file. dso2512g firmware install
as you would for any official firmware. However, there is one major prerequisite:
uses a relatively simple USB-based method to update its firmware. 1. Enter Firmware Update Mode Ensure the oscilloscope is (turned off). Press and hold the [mV] button.
for more advanced tasks like or serial decoding ? New 2ch pocket DSO+SG - Zeeweii DSO2512G - EEVblog The progress bar at the bottom will begin
Use the instructions from the custom firmware repository (e.g., taligentx/ZeeTweak ).
Many users opt for modified firmware versions found on platforms like GitHub (ZeeTweak) or the EEVblog forum . These community mods often provide:
Once the tool indicates "Success," release the Power button. Repeat the process using an older, stable version
Happy soldering and scope hunting!
If you want, I can:
