Mount the LNL-3300-M5 onto the existing standoffs inside the Micro5 enclosure. Secure it using the provided screws. Power Connections
Wear a properly grounded ESD (Electrostatic Discharge) wrist strap throughout the installation process. Step 2: Removing the Legacy Board
Illuminate when the respective strike or aux relay coil energizes. 🛡️ Commissioning and Software Setup lenel lnl3300m5 installation manual upd top
To enable default login: Once at the login screen, turn switch 1 to use the default credentials (username: admin , password: password ).
The M5 acts as the intelligent controller, typically interfacing with downstream modules (e.g., LNL-1300) to manage door readers. Power Supply: Use a regulated 12 VDC power supply. Mount the LNL-3300-M5 onto the existing standoffs inside
Log in using the factory credentials found in your deployment documentation.
To reset the controller to its factory default state (clearing all configuration and cardholder data): Step 2: Removing the Legacy Board Illuminate when
Verify network cable continuity and confirm the switch port is active. To help finalize your system configuration, tell me:
: Turn the panel off and then back on. Wait roughly 30 seconds for the reboot.