Mitutoyo Surftest Sv400 User Manual Full ^new^ File

Place the unit on a heavy, dedicated isolation table. Avoid proximity to heavy machinery, HVAC compressors, or high-traffic walkways.

: Clean the diamond tip with a lint-free cotton swab saturated in ultra-pure isopropyl alcohol. Wipe using a single, light motion from the base of the arm toward the tip. Never rub back and forth.

The SV-400 is capable of calculating a wide array of roughness parameters. The manual provides definitions and formulas for:

The SV-400 ships with mechanical shipping restraints on the X and Z axes. Remove these red or yellow shipping brackets before powering on the unit. mitutoyo surftest sv400 user manual full

Connect to a grounded AC power source. Turn on the main switch and allow the system electronics to thermally stabilize for at least 15 to 30 minutes before calibration. 3. The Control Panel and Software Interface

Crucial for ISO 9001 compliance. The manual dictates using the . It walks you through:

Check if the detector is securely attached. Place the unit on a heavy, dedicated isolation table

Remove any red shipping brackets or protective foam from the drive unit and detector before powering on the machine. Step-by-Step Operational Instructions 1. Hardware Assembly and Connection

The Mitutoyo Surftest SV-400 is designed to measure surface roughness, waviness, and other surface characteristics with high precision. It is widely used in industries such as automotive, aerospace, and manufacturing, where surface finish is critical for performance, safety, and durability. The device features advanced technology that allows for quick and accurate measurements, making it a valuable tool for quality control and assurance.

Verify that the stylus is in contact with the workpiece and that the drive unit is correctly positioned. Wipe using a single, light motion from the

Align the travel path of the X-axis drive unit parallel to the surface profile you want to measure. Lower the detector until the software's Z-axis level indicator is centered. Press . Ensure no external vibrations or bumps occur during the trace. 6. Understanding Parameters and Data Analysis

Press the "Start" button. The detector will traverse the surface, and the screen will display the profile and calculated values. 3.3 Data Output

: 0.75 mN or 4 mN (model-dependent configurations)