When the timer reaches zero, the unit will beep, entering the exhaust phase.
Clean the gasket. Replace it if hardened or cracked. Ensure the handle is fully rotated to the lock position.
If the manual is lost forever, do not despair. You can reconstruct a working knowledge base: sanyo mac 1200 autoclave manual
The "Heating" indicator light will illuminate. The internal heater will bring the water to a boil, displacing air with steam. Once the chamber reaches the target temperature and pressure, the timer will begin counting down. Step 5: Cycle Completion and Depressurization
Ensure the drain valve is fully closed before starting a cycle. When the timer reaches zero, the unit will
Operating the Sanyo MAC-1200 requires a clear understanding of its front control panel, which combines physical knobs, digital displays, and status indicator lights.
Approximately 0.12 to 0.15 MPa (1.2 to 1.5 bar / 17 to 21 PSI). Ensure the handle is fully rotated to the lock position
Verify the unit is properly grounded and the fuse is intact.
The MAC 1200 utilizes saturated steam to achieve sterilization. Sterilization Temperature: Typically ranges between 115°C and 135°C Standard Cycle: A common setting for effective sterilization is 121°C at 15 psi for approximately 15 to 20 minutes Media Requirements: Always use distilled water to prevent mineral buildup and damage to internal valves.