Simco Fmx002 Manual Full !!better!! (Desktop)

Industrial standards (such as ANSI/ESD S20.20) require periodic verification of ESD testing equipment. The FMX-002 should be calibrated once every 12 months. Equipment Required for Verification A variable DC high-voltage power supply ( A flat metal calibration plate (

integrates precision sensor circuitry inside a pocket-sized, ergonomically optimized conductive resin enclosure. Its internal architecture automatically handles range scaling to deliver precise voltage assessments. Simco FMX-002 Electrostatic Fieldmeter Calibration

Clean with dry compressed air. If error persists, factory service is required. Low battery voltage. Replace the 9V manganese battery. Unstable or fluctuating readings simco fmx002 manual full

Move the meter closer or further until the two red LED focus beams merge into a single, concentric circle. This ensures the precise distance required for accuracy. Read the voltage value on the LCD display: Displays up to with fine resolution. High Range: Automatically switches to display up to when high voltage is detected.

After approximately 15 hours of continuous use. The manual advises replacing the battery every 3 months even if not heavily used, because alkaline batteries can leak. Industrial standards (such as ANSI/ESD S20

Pull the meter away immediately to protect the sensor plate circuitry. Fluctuating or Unstable Readings Cause: Missing ground connection or high ambient humidity.

The device is intended for clean environments. Exposure to water, oil, or solvents will cause failure. Low battery voltage

Ensure you are aiming away from charged objects when zeroing. 6. Calibration Policy

The sensor aperture is extremely sensitive. Never touch the internal sensor elements with fingers, tools, or compressed air. If dust accumulates, gently blow it away using a clean, dry squeeze bulb.