Xycd60 Manual [updated] Jun 2026

A: For caliper version: Remove battery for 60 seconds, press ON/OFF three times (drains residual charge), reinstall battery. For timer version: Press and hold both SET and DOWN for 10 seconds – display flashes 8888.

This guide will focus primarily on the version, then provide a dedicated section for the Timer Relay at the end.

Here are some frequently asked questions about the Xycd60 manual: xycd60 manual

), and status symbols like "IN" (charging) or "OUT" (discharging).

These three timer functions give you fine control over the module’s behaviour, particularly useful in automated systems. A: For caliper version: Remove battery for 60

Connect the to the IN terminals and the load to the OUT terminals.

If your XYCD60 is a small, green or blue circuit board with an LCD display, you have a different device entirely. Here are some frequently asked questions about the

This occurs when the battery voltage fluctuates around the UP and dn thresholds, often due to high charger current or low battery capacity. The charger instantly reaches UP, the relay opens, the voltage drops to dn, and the relay closes again. Solutions include: